+30 mm Lift Springs for VW T6 2WD, Medium to Heavy Load

TREKFINDER® +30 mm Lift Spring Kit for VW T6 2WD (Medium to Heavy Load Applications)

The TREKFINDER® lift spring kit is designed for the VW T6 (excluding 4Motion and T6.1 models) and is suitable for vehicles with medium to heavy payloads. The springs provide approximately +30 mm of lift, improving both the appearance and ground clearance of your vehicle.

Specifications
Front axle: Linear-rate springs
Rear axle: Progressive-rate springs
Suitable for vehicles with medium to heavy payloads
Not suitable for vehicles equipped with a winch
Important Information Regarding Vehicle Lift Height

The stated lift of approximately 30 mm is a guideline value. The actual lift achieved may vary depending on the vehicle's condition, configuration, and equipment.

Why Can the Lift Height Vary?

Vehicle ride height is influenced by several factors, including:

Condition and age of the original springs and shock absorbers
Vehicle equipment and aftermarket accessories
Engine and transmission configuration
Payload and additional equipment
Tire pressure and tire size
Factory suspension variants (e.g. rough-road suspension packages)

Our lift specifications are based on extensive practical testing and many years of experience gained from hundreds of vehicle conversions. In most cases, the stated lift values are achieved very reliably.

What to Expect
Variations of approximately ±10 mm are completely normal with suspension modifications.
Front and rear axle lift may differ slightly due to vehicle design characteristics.
The springs will settle and reach their final ride height after a short break-in period.
Recommended Measurement Procedure

To accurately evaluate the height increase, we recommend:

Measuring and recording the vehicle height before installation
Marking wheel arch measurement points and using the same points afterward
Measuring the vehicle unloaded and on level ground
Taking before-and-after photos under identical conditions

This makes it easy to compare the results after installation.

Please Note

This spring kit is not a height-adjustable suspension system. The final ride height depends on the individual vehicle configuration and cannot be predicted with millimeter accuracy.

Suspension Information
Tested for use with OEM shock absorbers – no replacement dampers required
Not suitable for vehicles equipped with self-leveling suspension or air suspension
Suitable for towing applications, provided the tow ball height remains within the requirements of DIN 74058 (350–420 mm)
No technical concerns when used with approved wheel and tire combinations covered by valid certification
Package Contents
4 × TREKFINDER® coil springs (main springs)
1 × TÜV parts certificate (Teilegutachten)
Vehicle Compatibility

Please verify the following information against your vehicle registration documents.

Manufacturer

Volkswagen (VW)

Models
VW T6 Multivan
VW T6 California
VW T6 Transporter
Vehicle Type Codes
7HC
7HMA
7J0
Permissible Axle Loads
Front axle: up to 1,710 kg
Rear axle: up to 1,720 kg
EC Type Approval Numbers
e12001/1160220*36-...
e12001/1160289*25-...
e12007/460130*16-...

Important: This lift spring kit is suitable for VW T6 2WD models only. It is not compatible with VW T6 4Motion or VW T6.1 models.